Led Indications; Software Update - Toshiba 40LV655P Service Manual

forced when turning the main power ON
D1 (bit1) ~ Forced picture mode
D0 (bit0)

LED Indications

The LEDs on the TV (at the bottom of the TV) indicate the TV's status, as described below.
Red ON (solid) and Green OFF = The TV power cord is plugged in, but TV is in
Standby.
Green ON (solid) = The TV is powered on.
LED Indication
1 Green LED turns OFF.
Red LED blinks
continuously at 0.5sec
period.
2 Green LED turns OFF.
Red LED blinks
continuously at 1.0sec
period.

Software Update

1. Extract the update files onto a USB drive.
2. Unplug the TV.
3. Connect the USB drive to the USB port on the side panel.
4. Plug in the TV and watch the Green LED on the front of the TV set.
Once the update started, the Green LED blinks continuously.
5. When the Green LED turned ON (solid), the update has completed successfully.
6. Unplug the TV set.
7. Disconnect the USB drive.
Condition
BUS Error Turn OFF the TV and unplug the power
cord.
Plug the power cord in again and turn ON
the TV.
Power Protect Turn OFF the TV and unplug the power
Error cord.
Plug the power cord in again and turn ON
the TV.
0 [dec]: Dynamic
1 [dec]: Standard
2 [dec]: Mild
3 [dec]: Movie
Solution