Panasonic TH-80LFB70E Service Manual page 37

Caution when attaching P PCB Fixing Metal
• The Metal must not overlap the boss of LCD Panel.
• Tightened in order of (1-2), the other screws are free.
11. Remove the screws and then remove the VESA Metal Up
(with VESA Metal).
Attention when replacing LCD Panel
(1) Attach a VESA Metal Up (with VESA Metal) to the
LCD Panel for repair.
(2) As shown in the following figure, please attach
beforehand the Clamper for the LCD Panel.
(3) Check that the FFC (from V1-Board) and the
lead wire (from Touch Module) are taken
out to the outside of the Cabinet.
(4) Two person hold the narrow-side of LCD Panel
and raise it, and move to the Cabinet. Since the
worker who carries becomes a situation where the
circumference cannot be seen, in order that he
may guide safely, one person needs to do the
assistance under movement, and the directions
of a place to take down.
37
TH-80LFB70E