Panasonic TH-80LFB70E Service Manual page 34

TH-80LFB70E
• When replacing the LCD Panel, please replace the alumi-
num tape and wiring tape at the same time.
* The specifications of sticking may change without
notice and sometimes the parts may remain.
* Please stick on the same place as original places.
About the wiring tape
• Please use cutting according to the length of the tape stuck
on the LCD Panel before replacement.
• Although the color of a tape is different, there is no problem.
Caution when replacing LCD Panel
• Please be sure to remove metal fittings and attach them to
the LCD Panel for repair.
Caution when replacing/removing lead wire and FFC
• Please insert the lead wire and FFC firmly to the back of
connector.
The shortage of plugs causes failure.
• A lead wire is removed from a clamper if needed.
1. Prepare the stable level place covered with the soft cloth
and sponge for placing LCD Panel.
2. Remove the H1-Board.
(Refer to steps 1 to 2 in "7.5. Replacement of H1-Board")
3. Remove the Control Panel (with V2-Board and Power
Button).
(Refer to "7.12. Replacement of V2-Board")
4. Disconnect the connectors on the LCD Panel side.
5. Disconnect the connectors and remove the screws, and
then remove the Slot Block and A PCB Fixing Metal (with
A-Board, HX-Board and Speaker Block (L)) at the same
time.
Attention when removing Slot Block
• Remove the conductive tape and aluminum tape on the
LCD Panel.
34