Table of Contents
Advertisement
120 VICTOR
Power Connection
(EN)
P1
Red Stripe
2
1
10
9
200 mm ± 10
Connect end P1 to the module socket
Connect end P2 to the power supply
The VICTOR module comes with the required power cable
for connecting to a standard Eurorack power supply system.
Follow these steps to connect power tothe module. It is
easier to make these connections before the module has
been mounted into a rack case.
1. Turn the power supply or rack case power off and
disconnect the power cable.
2. Insert the 16-pin connector on the power cable into the
socket on the power supply or rack case. The connector
has a tab that will align with the gap in the socket, so it
cannot be inserted incorrectly. If the power supply does
not have a keyed socket, be sure to orient pin 1 (-12 V)
with the red stripe on the cable.
3. Insert the 10-pin connector into the socket on the back of
the module. The connector has a tab that will align with
the socket for correct orientation.
4. After both ends of the power cable have been securely
attached, you may mount the module in a case and turn
on the power supply.
Installation
The necessary screws are included with the module for
mounting in a Eurorack case. Connect the power cable
before mounting.
Depending on the rack case, there may be a series of fixed
holes spaced 2 HP apart along the length of the case, or a
P2
1
2
HOT USED
15
16
+ 12V
+ 12V
GROUND
GROUND
- 12V
- 12V
track that allows individual threaded plates to slide along
the length of the case. The free-moving threaded plates
allow precise positioning of the module, but each plate
should be positioned in the approximate relation to the
mounting holes in your module before attaching the screws.
Hold the module against the Eurorack rails so that each
of the mounting holes are aligned with a threaded rail or
threaded plate. Attach the screws part way to start, which
will allow small adjustments to the positioning while you
get them all aligned. After the final position has been
established, tighten the screws down.
Conexión Eléctrica
(ES)
P1
Red Stripe
2
1
10
9
200 mm ± 10
Connect end P1 to the module socket
Connect end P2 to the power supply
El módulo viene con el cable de alimentación necesario para
conectarse a un sistema de suministro de energía Eurorack
estándar. Siga estos pasos para conectar la alimentación al
módulo. Es más fácil realizar estas conexiones antes de que
el módulo se haya montado en una caja de rack.
1. Apague la fuente de alimentación o la caja del bastidor y
desconecte el cable de alimentación.
2. Inserte el conector de 16 clavijas del cable de
alimentación en la toma de la fuente de alimentación
o en la caja del bastidor. El conector tiene una pestaña
que se alineará con el espacio en el zócalo, por lo que
no se puede insertar incorrectamente. Si la fuente de
alimentación no tiene un enchufe con llave, asegúrese de
orientar el pin 1 (-12 V) con la raya roja en el cable.
Quick Start Guide
121
P2
1
2
HOT USED
15
16
+ 12V
+ 12V
GROUND
GROUND
- 12V
- 12V
Advertisement
Table of Contents
