Table of Contents
Advertisement
Please note that if the card is removed hastily from the antistatic bag, the plastic
ziplock may harm the EMI fingers on the networking connector. Carefully remove the
card from the antistatic bag to avoid damaging the EMI fingers.
2.
Shut down your system if active:
Turn off the power to the system, and disconnect the power cord. Refer to the system
documentation for instructions. Before you install the ConnectX-7 card, make sure that the
system is disconnected from power.
OCP 3.0 Bracket Replacement Instructions
Unable to render include or excerpt-include. Could not retrieve page.
OCP 3.0 Adapter Card Installation Instructions
Unable to render include or excerpt-include. Could not retrieve page.
Cables and Modules
To obtain the list of supported NVIDIA cables for your adapter, please refer to the
Table at Networking Configuration
Cable Installation
1.
All cables can be inserted or removed with the unit powered on.
2.
To insert a cable, press the connector into the port receptacle until the connector is firmly
seated.
a.
Support the weight of the cable before connecting the cable to the adapter card. Do
this by using a cable holder or tying the cable to the rack.
b.
Determine the correct orientation of the connector to the card before inserting the
connector. Do not try and insert the connector upside down. This may damage the
adapter card.
c.
Insert the connector into the adapter card. Be careful to insert the connector straight
into the cage. Do not apply any torque, up or down, to the connector cage in the
adapter card.
d.
Make sure that the connector locks in place.
When installing cables make sure that the latches engage.
Always install and remove cables by pushing or pulling the cable and
connector in a straight line with the card.
3.
After inserting a cable into a port, the Yellow or Green LED0 indicator will light when the
physical connection is established (that is, when the unit is powered on and a cable is
plugged into the port with the other end of the connector plugged into a functioning port).
See Adapter Card LED
Tools.
Operations.
Cables Reference
23
Advertisement
Table of Contents
Troubleshooting
