Table of Contents
Advertisement
Replacing the Projection Lamp
The projection lamp should be replaced when it burns out. It should only be replaced with a certified
replacement part, which you can order from your local dealer.
Important:
1. The lamp contains a certain amount of mercury and should be disposed of according to local or-
dinance regulations.
2. Avoid touching the glass surface of the new lamp: Doing so may shorten its operation life.
Warning:
1. Be sure to turn off and unplug the projector at least an hour before replacing the lamp. Failure to
do so could result in a severe burn.
2. It is recommended that you do not attempt to replace the lamp while the projector is installed on
a ceiling. If you do attempt this, wear protective goggles to prevent glass from a ruptured lamp get-
ting into your eyes.
1.
Lift the screw cover (A).
Remove the screw on the lamp com-
partment cover (B) and then lift the
lamp compartment cover (C).
2.
Remove the two screws from the lamp
module (A) and then lift the module
handle up (B).
3.
Pull up firmly to remove the lamp
module.
4.
Reverse Steps 1 to 4 to install the new
lamp module.
Note: The lamp module should be ori-
ented as shown here when replacing.
ViewSonic Cine1000
M
AINTENANCE AND
M
a
i
n
t
e
n
a
n
c
e
a
n
d
S
M
a
i
n
t
e
n
a
n
c
e
a
n
d
S
M
a
i
n
t
e
n
a
n
c
e
a
n
d
S
S
ECURITY
e
c
u
r
i
t
y
e
c
u
r
i
t
y
e
c
u
r
i
t
y
29
Advertisement
Table of Contents
