Yamaha MT-10 2020 Owner's Manual page 31

The tachometer allows the rider to
monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the ta-
chometer will sweep across the r/min
range and then return to zero r/min in
order to test the electrical circuit.
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 11800 r/min and above
Clock
1
1. Clock
The clock uses a 12-hour time system.
To set the clock
1. Turn the key to "ON".
2. Push the "CLOCK" button for two
seconds.
3. When the hour digits start flashing,
push the "RESET" button to set the
hours.
ECA10032 4. Push the "CLOCK" button, and the
minute digits will start flashing.
5. Push the "RESET" button to set
the minutes.
6. Push the "CLOCK" button and
then release it to start the clock.
Fuel meter
1. Fuel meter
The fuel meter indicates the amount of
fuel in the fuel tank. The display seg-
Instrument and control functions
ments of the fuel meter disappear to-
wards "E" (empty) as the fuel level
decreases. When the last segment
starts flashing, refuel as soon as possi-
ble.
TIP
If a problem is detected in the electrical
circuit, the fuel level segments and " "
will flash repeatedly. If this occurs, have
a Yamaha dealer check vehicle.
Coolant/Air temperature display
1
1
1. Select switch "SELECT"
Push the select switch "SELECT" for
two seconds to switch the display be-
tween the coolant temperature mode
"F" and air temperature mode "Air – –
5-8
1
2
3
4
5
6
7
8
9
10
11
12