Siemens LU 14122 FF Manual page 27

Fitting the extractor hood
To a wall-hanging cupboard
50 cm wide extractor hood:
With 4 screws.
60 cm wide extractor hood:
With 4 screws.
90 cm wide extractor hood:
With 6 screws.
1. Dimensions for the mounting boreholes
can be found in, or place a template on
the base of the wall-
hanging cupboard.
2. Mark the mounting holes and make pilot
holes with a bradawl.
In exhaust-air mode (upwards) mark the
exhaust-air opening and saw out.
Consider the location of the
connection cable; if required, saw out
the cupboard.
3. Remove the filter grille
(see Instructions for use).
4. Screw the extractor hood to the base of
the cupboard.
27