Table of Contents
Advertisement
/
TRACTOR DRIVE
At start of season, grease gears, pinion sprocket, hex and axle
shaft as indicated in Figure 13. Use Ariens Moly Lithium grease.
Put two or three drops of light oil on speed selector and other
linkage points.
CAUTION:
Do not allow grease or oil to
come in contact with friction wheel, drive disc or belts.
SNO-THRO UNIT
ZERK FITTINGS
SHEAR BOLTS
Ol L FI LL
FIGURE 14
NOTE:
When replacing a worn or broken shear bolt, use
ARIENS
shear bolts only.
Grease rake shaft periodically or each time a shear bolt is re¬
placed. At the end of the'season, remove shear bolts, use a
grease gun on zerk fittings to grease rake shaft, turn rakes on
shaft several times and replace shear bolts. See Figure 14. Use
Ariens Moly Lithium grease.
MODEL 924052 GEARCASE
Check oil level periodically. Oil level must be up to oil fill hole.
Change oil every 25 hours or once each season which ever
comes first.
Fill with Ariens Special L-2 Gear Lubricant.
Approximately 5 oz.
FIGURE 15
MODELS 924046,924048 & 924050 GEARCASE
The blower gear case is lubricated with Ariens Liquid
Grease- (Part No. 000070). This grease will not flow at lower
temperatures. It is therefore difficult to check the lubricant
level. Best method for checking is to place the unit in a warm
location overnight. This allows the grease to flow to level.
Check the lubrication by removing the filler plug on the side
of the gear case just above the left auger shaft. Lubrication
should be even with the hole with the machine sitting level. It
may be necessary to insert a wire into the hole to check level.
The unit will not be damaged by over lubricating.
STORAGE
ENGINE: Follow detail instructions in the engine manual.
SNO-THRO: Lubricate, clean and repaint as necessary.
Cover and store in dry place.
-
8
-
Advertisement
Table of Contents
