Door Panel Installation - Stainless Steel - Fisher & Paykel RS90AU Installation Manual

Door panel
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
z
attachment kit
Ensure to protect the finish of the Stainless steel door panels.
z
For non-water dispensing door panels: Leave the protective film on the panels when hanging and remove the film only when installation is complete.
z
Door handle kit available and must be purchased separately. Refer to 'Supplied parts' for more details.
z
Side bracket (10x)
Side strap (10x)
Door handle kit
M5x25 pan head socket
screw (12x)
Door panel set
1
M5x14 mush cross-head
(SS) screw (34x)
Tools
Hex key
FPA spanner
Powered driver
26
DOOR PANEL INSTALLATION — STAINLESS STEEL
A
Remove hanging brackets
Remove the M8 washers and
M8 nuts from the M8 studs at
the top the door.
Keep the washers and nuts
z
to reuse later.
Remove the hanging bracket
from the top of each door and
set aside for later installation.
1
2
3
Attach the door and drawer
handles
Remove the plastic film and blue
tape on the door panels.
Remove the plastic plugs from
the handle holes (4 per each door
panel).
Align the handle holes with the
door panel holes and secure with
M5x25 pan head socket screws
(4 per each door panel).
Attach the hanging brackets
Align the bracket to the holes and
secure with M5x14 mush cross-
head SS screws (14).
Attach the side brackets
Align the brackets and straps to
the holes on the side of the panel
and secure with M5x14 mush cross-
head SS screws (20).