ViewSonic P810 User Manual page 12

To exit the OnView
ViewMeter
15 pin mini D-sub and a BNC connector allowing you to connect
two computers.
ViewMeter displays the frequency signal input (horizontal
scan and refresh rate) coming from the graphics card in
your computer. See your graphics card user guide for more
details. To switch between active ports, from the screen
shown below, press [M] or [L]. Note. When the horizontal
or vertical sync signal are outside the permitted range, the
screen below appears.
If no signal input comes from your computer, the screen
shown below appears: the cable may not be connected or
the monitor is in power saving mode.
Shortcut. Before displaying the main menu, press button
[2] to display the ViewMeter screen shown below.
Degauss removes the buildup of magnetic fields that can
cause irregular colors to appear around the edges of screen
images. There are three ways to degauss the monitor;
automatically by turning the monitor on, manually by
selecting the Degauss control from the OnView Main
Menu, or with the ViewMeter
button [2].
Important: Do not degauss repeatedly. Doing so can be
harmful to the monitor. Wait at least 20 minutes before
selecting this control again.
ViewSonic P810
®
menu & save changes, press button [1].
®
/Degauss: The P810 is equipped with ports for a
View Me te r
1280 x 10 24
Port
1 :Exit
View Me te r
No S i
Port
1 :Exit
fH
fV
D e
g
From this screen, press button
[2] to select Degauss.
fH
n al
g
fV
D e
g
From this screen, press button
[2] to select Degauss.
®
control displayed, press
63.7kHz
60.1kHz
a u s s : 2
- - . - kHz
- - . - kHz
a u s s : 2
Operation 11
E
N
G
L
I
S
H