Installing The Processor; Removing The Vga Daughter Board - Dell OptiPlex 7040-Small Form Factor Owner's Manual

c. Lift the processor out of the socket [3].

Installing the processor

Steps
1. Align the processor with the socket keys.
2. Align the pin-1 indicator of the processor with the triangle on the socket.
3. Place the processor on the socket such that the slots on the processor align with the socket keys.
4. Close the processor shield by sliding it under the retention screw.
5. Lower the socket lever and push it under the tab to lock it.
6. Install the:
a. heat sink
b. fan duct
c. optical drive
d. hard drive assembly
e. front bezel
f. cover
7. Follow the procedure in

Removing the VGA daughter board

Steps
1. Follow the procedure in
2. Remove the:
a. cover
b. fan duct
3. To remove the VGA daughter board:
a. Remove the screws that secure the VGA connector to the computer [1].
b. Slide the VGA connector to release it from the computer [2].
c. Remove the screw that secures the VGA daughter board to the computer [3].
d. Lift the VGA daughter board using the handle to remove it from the computer [4].
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
Removing and installing components 17