Quasar MQS1063EV Operating Instructions Manual page 12

Clock Setting
Example: To set 11:25
« Press.
» Dot blinks.
* Enter time of day using
number pads.
»Time appears in the
display; dot is blinking.
* Press.
» Dot stops blinking; time of
day is entered and locked
into display.
NOTE:
1.You can use the oven without setting the clock.
2.There is no a.m. or p.m. settings. Clock is a 12
hour display.
3.To reset time of day, repeat the steps above.
4.The clock will retain time setting only when
plugged into power source.
> Oven will not operate while dot is blinking.
To Use Popcorn Pad
Example: To heat 3.5 oz. of prepackaged
microwave popcorn
1. * Set the desired weight of
prepackaged microwave
popcorn. (See Chart
below.)
Press once
* Press Start Pad.
» Cooking time appears in
the display and begins
to count down.
NOTES ON POPCORN PAD:
1, Use prepackaged room temperature microwave
popcorn. Read manufacturers' instructions.
2. Place bag in oven according to manufacturers'
directions.
3. Pop only one bag at a time.
4. After popping, open bag carefully, popcorn and
steam are extremely hot.
5. Do not reheat unpopped kernels or reuse bag.
6. The recommended weights are already
programmed in the memory.
7. Never leave oven unattended when popping
popcorn.
once
twice
3 times
CAUTION:
If pre-packaged popcorn is of a different weight
than those on the chart, do not use the popcorn
setting, or inadequate popping or a fire may occur.
Follow the manufacturers' instructions.
Power & Time Setting
How do | program power and time?
Example: To cook at MEDIUM Power for
5 minutes.
e Select power level
(according to the chart
below).
* Set cooking time using the
number pads.
(up to 99 minutes and 99
seconds for a single stage).
« Press Start.
» Cooking will start.
The time in the Display
Screen will begin to count
down.
To recall the selected
power level during cooking,
press Power Level Pad.
NOTE:
1.For 2 or 3 stage cooking, repeat steps 1 and 2
above before pressing Start Pad.
2.When selecting HIGH power, you can Start from
step 2.
once P 100 HIGH
twice dEF DEFROST
3 times P 70 MEDIUM-HIGH
4 times P 50 MEDIUM
5 times P 30 MEDIUM-LOW
6 times P 10LOW
Child Safety Lock
This feature allows the prevention of use by children
(not including door mechanism).
You can set Child Lock when the display shows a
dot or time of day.
To Set:
« Press 3 times.
»"CHILD" appears on the
Display Screen.
To Cancel:
t. HOLD/CLEAR
* Press 3 times.
» Dot or time of day
reappears in the Display
Screen.
-10-