Yamaha FJR13ESM 2020 Owner's Manual page 38

Instrument and control functions
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
4
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
the switch down towards " ". See
page 6-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
/ "
". To signal a left-hand
". When
"
/ /
", and then push
" to stop the en-
" posi-
EAU12461
Cruise control switches
See page 4-4 for an explanation of the
cruise control system.
Menu switch "MENU"
This switch is used to make setting
changes within the multi-function me-
ter unit. (See page 4-7.)
EAU12501
Select switch "
This switch is used to make setting
changes within the multi-function me-
EAU54212
" ter unit. (See page 4-7.)
Drive mode switch "MODE"
WARNING
Do not change the D-mode while the
vehicle is moving.
Using this switch changes the drive
mode to touring mode "T" or sports
mode "S".
The throttle grip must be completely
EAU12735
closed in order to change the drive mo-
de.
The selected mode is shown on the
drive mode display. (See page 4-9.)
The drive mode cannot be changed
while the cruise control system is oper-
ating.
ECA10062
4-21
EAU12781
EAU54232
EAU54222
/ "
EAU54691
EWA15341