Connect Dc Power To The Chassis - Ncs-950W-Dcfw And Nc55-2Kw-Dc - Cisco NCS55A1 Hardware Installation Manual

Connect DC Power to the Chassis - NCS-950W-DCFW and NC55-2KW-DC

Connect DC Power to the Chassis - NCS-950W-DCFW and
NC55-2KW-DC
The chassis relies on the protective devices in the building installation to protect against short circuit,
Caution
overcurrent, and ground faults. Ensure that the protective devices comply with local and national electrical
codes.
Step 1 Verify that the correct fuse panel is installed in the top mounting space.
Step 2 Measure and cut the cables as needed to reach the chassis from the fuse panel.
Step 3 Dress the power according to local practice.
Step 4
Connect the office battery and return cables according to the fuse panel engineering specifications.
Step 5 Insert the DC connector into the DC receptacle on the power supply:
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
32
Install the Chassis