Table of Contents
Advertisement
Navigating Between Modes
Each press of (C) cycles between watch
modes.
Timekeeping Mode
C
C
Alarm Mode
Stopwatch Mode
C
World Time Mode
Timer Mode
C
Cycling Between
Timekeeping Mode Digital
Display Contents
Each press of (D) in the Timekeeping Mode
cycles the display information as shown
below.
Month, day
Hours, minutes
Seconds
Watch Operation Guide 5715
Viewing the Face in the Dark
The watch has an LED light that you can turn
on for reading in the dark.
To illuminate the face manually
●
Press (B) to illuminate the face and digital
display.
Illumination will turn off automatically if an
●
alarm starts to sound.
To illuminate the face when Auto Light
●
is enabled
If Auto Light is enabled, face illumination will
turn on automatically whenever the watch is
positioned at an angle of 40 degrees or more.
C
Important!
Auto Light may not operate properly
●
when the watch is at a horizontal angle
of 15 degrees or greater from
horizontal as shown in the illustration
below.
Electro-static charge or magnetism
●
can interfere with proper auto light
operation. If this happens, try lowering
your arm and then angle it towards
your face again.
When moving the watch you may note
●
a slight rattling sound. This is due to
operation of the auto light switch,
which determines the current
orientation of the watch. It does not
indicate malfunction.
Seconds
Note
Auto Light is disabled when any one of
●
the conditions below exists.
Alarm, timer alert, or other beeper
ー
sounding
Configuring the Auto Light Setting
●
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (B) for at least three seconds
to toggle Auto Light between enabled and
disabled.
[A.LIGHT] is displayed while Auto Light
●
is enabled.
Note
40
degrees
or more
If you do not disable it manually, Auto
●
Light remains enabled for
approximately six hours. After that, it
becomes disabled automatically.
6
Advertisement
Table of Contents
