Table of Contents
Advertisement
Viewing the Speed Display
When measuring the elapsed time in
Stopwatch Mode, the speed value is obtained
by dividing the specified distance by the
measured elapsed time (in hours).
Speed (100s digit)
Speed (1000)
Elapsed time (hours)
Speed (Less than
Elapsed time
100s digit)
(1/1000 seconds)
Elapsed time (seconds)
Elapsed time (minutes)
The 100s digit is indicated by the upper
●
speed (100s digit) graphic.
If it exceeds 1000, the [
] 1000 graphic
●
is displayed.
Values less than the 100s digit are indicated
●
by the speed hand. Only even numbers are
indicated.
Example:
When the speed is 1740, the [
graphic is displayed.
The upper speed (100s digit) graphic
shows 700.
The speed hand points to 40.
Speeds can be indicated in the range of 0
●
to 1998. [OVER] is displayed for speeds
greater than 1998.
Note
If you specify a distance of 0.0, 0 will
●
be shown for the speed. At this time,
the speed hand makes one revolution
and returns to the 0 position.
Button operations are disabled while
●
the speed hand is moving.
Watch Operation Guide 5715
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
Using a Timer
●
Your watch provides you with two different
types of timers. Select the timer you want to
suit your needs.
Repeat Timer
●
With the Repeat Timer, countdown stops
and the start time setting appears when the
end of the countdown is reached.
The Repeat Timer comes in handy when
you need to perform the same countdown
operation a number of times.
Auto Repeat Timer
●
With Auto Repeat Timer, the countdown
] 1000
operation is automatically restarted from the
start time when the end of the countdown is
reached. This continues until you stop the
countdown operation.
Timer
Setting the Countdown Start
Time
The countdown start time can be set in 1-
minute units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least three seconds.
Release the button when the hour digits
start to flash.
Hours
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the minutes
setting.
6.
Press (C).
7.
Press (D) to select Repeat Timer or Auto
Repeat Timer.
Each press of (D) toggles between
●
[
] (Repeat Timer) and [
(Auto Repeat Timer).
8.
Press (A) to complete the setting
operation.
Note
Setting a start time of "0:00" will
●
perform a countdown of 24 hours.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
]
13
Advertisement
Table of Contents
