Table of Contents
Advertisement
5. FINE TUNE
This parameter sets the fine tuning (detune) of each MIDI channel. Normally, the COARSE TUNE is
made first and then refined with FINE TUNE.
Notes
parameter.
6. COARSE TUNE
This parameter tunes each MIDI channel.
7. EXPRESSION
This parameter sets the expression of each MIDI channel.
Note
* VOLUME and EXPRESSION are basically the same setting. Normally, VOLUME is used to auyusi
the overall volume of all channels, while EXPRESSION is used to change the intonation within a
song.
MIDI channel assignments during data receive
ee ed
fn few | fowew | | [0 [oe | 0
Highend
|Highend
|Lowend
jLowend
Layer + Split
layered tone eee
al Chord 1 | Chord2
| Chord3
Layer + Split
Rhythm
Note
* MIDI Channels 1 through 3 are used when Magical Preset is being used.
E-84
Technical Reference
Troubleshooting
Probabie Cause
No sound when key- | 1. Power supply problem
board
keys
are
pressed.
. Make sure the AC adaptor is con-
nected, or that batteries are. not
dead and are loaded correctly (with
+ and - ends facing in the right di-
rections).
:
2. Slide the VOLUME
controller to-
wards MAX.
3. Disconnect the headphones from
the keyboard.
4. Use the MODE button to turn off
the mode indicators.
. VOLUME is set to MIN.
. Headphones are connected.
. Attempt to play notes on accompa-
niment keyboard while the CASIO
CHORD or FINGERED mode indi-
cator is lit.
. Adrum set (dr.0 to dr.7) is selected.
5. Any of these settings disable the 16
keyboard keys on the far left and
the seven keyboard keys on the far
right.
6. Turn the LOCAL CONTROL param-
eter on.
7. Press the button so the indicator
8
1
. The LOCAL CONTROL
parameter
is off,
. Mixer channel? 1 is off.
lights.
. Increase channel 1 volume.
. Use the ACCOMP VOLUME button
to adjust the accompaniment vol-
ume.
2. Tum the rhythm part on.
3. Adjust the rhythm volume.
. Mixer channel 1 volume is set to 000.
. Accompaniment volume is set to
000.
No rhythm sound
. The rhythm part is cancelled.
. The Accompaniment Mixer rhythm
volume is set to 0.
. Accompaniment volume is set to
000.
@ONr
. Use the ACCOMP VOLUME button
to adjust the accompaniment vol-
ume,
. Turn the part on.
No auto-accompani-
ment sound
2. The accompaniment
part is can-
celled.
3. The Accompaniment Mixer volume
for the part is set to 0.
. Mixer buttons CH1 through CH4 are
turned off (indicators are not lit).
2. Volume is set to "000".
3. Adjust the part's volume.
. Press Mixer buttons CH1 through
CH4 to turn their indicators on.
2. Use the Mixer to increase volume.
Layer and split indi-
cators are lit, but no
sound is produced.
* No pad sound out-
put.
One of the following
symptoms when using
batteries
Low battery power
Replace batteries with new ones
@ Dim POWER indicator
| © Spontaneous sound out-
@® Low volume
put when keyboard keys
@® Sound distortion
are not pressed
@ Interruption of sound at
@ Tone
output different
high volumes
from selected tone
© Sudden power outage
Abnormal
sound during
at high volumes
rhythm or demo tune play
E-85
Advertisement
Table of Contents
