Side Panel Connections; Led Indicators - Watchguard AP430CR Hardware Manual

Side Panel Connections

LED Indicators

LED Indicators
Wi-Fi in WatchGuard Cloud access points have LED indicators that can show different status conditions while
booting, activation validation, feature key download, WatchGuard Cloud device registration, and the connection
to WatchGuard Cloud.
The access point briefly passes through each stage until the device is connected to WatchGuard Cloud and
shows a solid blue LED indicator. If the access point remains in the same state for a long period of time without
a solid blue LED indicator status, there might be a network issue, activation or feature key issue, or a problem
with your WatchGuard Cloud account.
Check the following table for the status of the LED indicators and how to troubleshoot the issue.
LED Color Status
Solid Red or Device is booting
Orange
Validate access
Flashing Red
point activation
or Orange
and download
(Fast: 100
feature key
milliseconds)
Troubleshooting
If the access point remains in this state, the access point processes
might not have started, or there might be an issue with the access
point firmware.
Disconnect and reconnect power to reboot the access point to
see whether the device connects.
Try to log in to the access point Web UI or command line
interface (CLI) to check the device status, current firmware
version, and run diagnostic tests. For more information, go to
Access Point Web UI
If the access point remains in this state:
Make sure you have activated your access point with a valid
device serial number and license key in your WatchGuard
account. The license key must be for a WatchGuard Standard or
USP Wi-Fi license for Wi-Fi in WatchGuard Cloud.
Make sure the access point is connected to the network and has
received an IP address from DHCP.
Make sure the access point can connect to *.watchguard.io for
product activation and feature key updates.
or Access Point Command Line Interface.