Head Assembly - Teac A-2340 Service Manual

5.HEAD ALIGNMENT —MECHANICAL—
NOTE
Head alignment is adjusted at the factory to very critical
tolerances. Normally HEAD ASSEMBLY replacement will require
only minor alignment or adjustments.
Complete readjustment should only be necessary after an in-
dividual head is replaced.
The adjustments are made as follows:
ERASE HEAD SECTION
The erase head pole should be above the edge of a threaded tape by
the width of heavy pencil line.
RECORD HEAD SECTION
The record head pole should be above the edge of a threaded tape by
the width of a thin pencil line.
PLAYBACK HEAD
The pole of the playback head should be even with the top of a
threaded tape.
@P & AZIMUTH ADJ. SCREW
@% HEIGHT ADJ. SCREW
ERASE RECORD PLAY BACK
Fig. 5-1 Head Alignment and Adjustable Screws.
NOTE
Azimuth adjustments are given in the section on MEASUREMENTS and
ADJUSTMENTS -ELECTRICAL-.