Table of Contents
Advertisement
Procedure
1. Remove the 4 screws
(@~ @).
Procedure
4>8+15
2. Remove the 1 flat cable (CN103).
15 +16
3. Remove the 1 connector (CN451).
Servo P.C.B.
S
Spindle motor terminals
1. Remove the 3 screws (@~®).
2. Unsolder the 2 terminals of spindle motor.
3. Remove the FPC board from the optical pickup.
Caution: To prevent the breakdown of the laser
diode, antistatic shorting pin is inserted
into the FPC board.
Proced
i
1. Remove the 2 screws (O, @).
2. Unsolder the 2 terminals and remove
the 2 screws (®, ©).
Unsolder
Caution: Take care not to touch the brush terminal.
Loading motor (2) terminals
Advertisement
Table of Contents
