Dimplex Vivente VVT775 Operating Instructions Manual page 9

Remote control
The fireplace is supplied with a remote control.
Operating Instructions using REMOTE CONTROL - See Figure 17
Icon Display Function
"FIRE" / Power /
A
"ST.BY" Standby
B "TIMR"
Smart-
C "SNSR" Sense
"ON" Heat Mode
D
"OFF" Heat Mode
E "15ST"
F "32ST" Temp Up
Flame
G "-F1-" Brightness
Flame
H "-F6-" Brightness
Volume
I "VOL1"
Volume
J "VOL6"
Ambient
K "AMB1"
L "LGT1" Selection
Button
All manuals and user guides at all-guides.com
Description
Press Once to turn the product on. ("ON")
Press a second time to put the product into standby. ("ST.BY" is shown, then "." is displayed
to indicate standby.)
(When returning from 'STANDBY' mode the product will return to previous settings unless the
product has been unplugged, in which case it will reset to factory settings)
This Button changes the timer setting. This can be set between 0.5 Hrs and 8.0Hrs in incre-
Timer
ments of 0.5 hrs. ("0.5Hr" to "8.0Hr + OFF") Each Button press will increase timer setting by
Cycle 0.5hrs.
This Button cycles through the SmartSense settings. Display will read; "MIN", "MAX" or
"OFF".
"MIN" turns product off 0.5 hour after last movement detected in room.
Cycle
"MAX" turns product off 3 hour after last movement detected in room.
"OFF" - SmartSense is turned off
First Button press activates the heat. Display reads "ON - XXST - XX
Second button press deactivaes the heat. Display shows "OFF"
Press Once to display current Set Temperature.
Temp
Down Press multiple times to lower the heater temperature in 1
temperature that can be set is 15
Press Once to display current Set Temperature.
Press multiple times to increase the heater temperature in 1
temperature that can be set is 32
Press Once to display current flame brightness setting.
Press to reduce the flame brightness setting. Range is from "-F1-" to "-F6-" and "OFF".
Down
Press Once to display current flame brightness setting.
Press to increase the flame brightness setting. Range is "OFF", then "-F1-" to "-F6-"
Up
Press Once to display
Down
Press to reduce the volume setting. Range is "OFF", then "VOL1" to "VOL6".
Press Once to display current volume setting.
Up
Press to increase
Press once to display current Ambient Setting. Subsequent presses will cycle through the
settings. Range is from "AMB1" to "AMB7". "AMB8" will also display once it is activated via
Cycle
the app.
Light
Press once to show all top lights and fuelbed and flame colour lights ON. Subsequent
presses cycle through ON/OFF settings for each of these lights. "LGT1" to "LGT5"
C.
0
C.
0
current volume setting.
the volume setting. Range is "OFF", then "VOL1" to "VOL6".
9
C"
0
C increments. The lowest
0
C increments. The highest
0