Table of Contents
Advertisement
You can adapt the programming of the
hob to your personal needs. Several
settings can be altered in succession.
After accessing programming mode,
the symbol appears and will
appear in the timer display. After a few
seconds : (Programme 01) will flash
alternately with : (Code) in the timer
display.
Change programming
Accessing programming mode
The sensor is located approx.
1 cm (index finger width) to the left of
the sensor.
With the hob switched off, touch
the and sensors at the same
time until the symbol and
appear in the timer display.
Setting a programme
For a two digit programme number
you need to first set the tens position.
Whilst the programme is visible in the
display (e.g. :), touch
the sensor repeatedly until the
number for the programme you want
appears in the display or touch the
appropriate number on the numerical
keybank.
Setting the code
Whilst the code is visible in the
display (e.g. :), touch
the sensor repeatedly until the
number for the code you want
appears in the display or touch the
appropriate number on the numerical
keybank.
To save the settings
While the programme is showing in
the display (e. g. :) touch the
sensor until the indicators go out.
To avoid saving the settings
While the code is showing in the
display (e. g. :) touch the
sensor until the indicators go out.
Programming
45
Advertisement
Table of Contents
