DeLonghi Dinamica Plus Instructions For Use Manual page 25

PROBLEM
The milk presents large bubbles or
splashes from the milk spout (E5) or is
under-frothed.
The machine emits noises or small
puffs of steam while not in use
The cup shelf (A12) is hot.
After cleaning, the drip tray (A15) can-
not be put back in the machine
The appliance emits puffs of steam
from the drip tray (A15) and/or there
is water on the surface the appliance
rests on.
POSSIBLE CAUSE
The milk is not cold enough, or the
type of milk not suitable for the drink
requested
The froth adjustment dial (E1) is incor-
rectly adjusted.
The lid (E2) or the froth adjustment dial
(E1) of the milk carafe are dirty
There is water in the channel on the
underside of the froth adjustment dial
(E1),
Vegetable drinks are being used.
The hot water connection nozzle (A8)
is dirty
The machine is ready for use, or has re-
cently been turned off, and condensate
is dripping into the hot vaporiser
Several drinks have been prepared in
rapid succession
The condensate tray(A10) is not in the
correct position
The drip tray grille (A14)has not been
replaced after cleaning.
25
REMEDY
To ensure optimum results, check that the right
type of milk is used when preparing hot drinks
or cold drinks (see section "9.1 Che latte utiliz-
zare?"). Use drinks at refrigerator temperature
(about 5° C).
Adjust following the instructions in section "9.
making hot milk-based drinks".
Clean the lid and adjustment dial of the milk
carafe as described in section "12.10 Cleaning
the milk carafe".
Detach the dial and dry thoroughly.
For best results, use drinks at refrigerator tem-
perature (about 5° C). Adjust the amount of
froth as described in section "9.3 Adjusting the
amount of froth"
Clean the connection nozzle as described in
section "12.11 Cleaning the hot water nozzle".
This is part of normal operation. To limit the
phenomenon, empty the drip tray.
Make sure the condensate tray is inserted
correctly
Reposition the grille in the drip tray.