Advertisement
Cleaning the Filters & Separator
1.
Remove dirt tank by
pressing release button and
lift tank away from vacuum.
4.
To access pre-motor filter,
lift release latch on front
of tank to lift lid.
Maintaining Your Vacuum
For more helpful maintenance tips, check out support.BISSELL.com.
Maintaining the TurboBrush® Tool
1.
Twist gray collar counterclockwise until slot
appears; separate faceplate and remove brush.
Replace belt and brush if needed.
2.
If paddle wheel is dislodged, align two clips on
each side and click into place.
3.
Faceplate will not close if all parts are not
aligned correctly.
Clearing a Clog
1.
Remove hose from back of vacuum by twisting
left. Remove any debris.
2.
Check foot hose on back of vacuum, towards
the bottom. If necessary, remove screw from foot
hose and check for clogs.
3.
Check air passageway on the bottom of
vacuum. Remove bottom cover and brush.
Remove any debris.
BISSELL proudly supports BISSELL Pet Foundation® and its mission to help save homeless pets.
When you buy a BISSELL® product, you help save pets, too. We're proud to design products that help
make pet messes, odors and pet homelessness disappear. Visit BISSELLsavespets.com to learn more.
4
2.
With dirt tank removed,
press filter cover release
button to access post-motor
filter.
5.
Remove pre-motor filter
from tank lid. Clean with
warm water and allow to dry
completely before reinserting.
Every Purchase Saves Pets
©2023 BISSELL Inc. All rights reserved.
Part Number 1629467 11/22 RevC
3.
with mild detergent and warm
water. Allow to dry completely
before reinserting.
6.
by twisting counterclockwise.
Pull out through the bottom.
Rinse and dry with a cloth.
Replacing the Brush and Belt
1.
Unplug vacuum, turn over and unscrew six
Phillips-head screws to remove bottom cover.
2.
Lift brush roll straight out. Inspect belt,
replace if it appears damaged.
3.
If belt is not broken. Inspect brush roll by
placing it on its end and spinning. Brush roll
should spin freely, multiple times with one flick.
Replace brush roll if it doesn't spin freely
4.
Replace brush roll and belt by looping belt
over motor shaft and brush roll. Line up endcaps
and pull brush forward into place. Belt will
stretch.
5.
Once brush roll is installed, place bottom cover
back on and replace screws.
Clean post-motor filters
Remove separator from tank
™
Advertisement
