Pioneer PD-Z84M Service Manual page 13

PD-284M, PD-2970M.
1.RESISTORS :
Indicated in 2, 1/4W, 1/6W and 1/8W, 5% tolerance unless
otherwise noted k; ki, M; MN, (F); +£1%, (G); +£2%,
(K); +10%, (M); 20% tolerance.
2.CAPACITORS :
Indicated in capacity (F)/voltage(V) unless otherwise noted p;
pF. Indeication without voltage is 50V except electrolytic
capacitor.
3.VOLTAGE, CURRENT :
; DC voltage (V) at no input signal.
<amA_ ;DC current at no input signal.
Value in ( ) is DC voltage at rated power.
4.OTHERS :
=» ; Signal route.
@ ; Adjusting point
The A\ mark found on some component parts indicates the
inportance of the safety factor of the part. Therefore, when
replacing, be sure to use parts of identical designation.
% marked capacitors and resistors have parts numbers.
This is the basic schematic diagram, but the actual circuit may
vary due to improvements in design.
< ° ~
5
oa fo)
o _ _
Cc
i
: 2 eisl|s
Q _ fe)
i) _ _ eel
_ © x mm] co] bo
=
Z
jis] 5 [32] oo [4st oo |
15