Table of Contents
Advertisement
Troubleshooting
Sound is not output or the volume is very low
→ Check the headphone and LINE OUT connec-
tions.
→ Confirm that the headphone volume and line
output level are not too low.
→ Check the orientation of the mic or the volume
settings of the connected equipment.
→ Check the mixer settings.
Monitored sound is distorted
→ Use
to adjust the volume.
"MIC INPUT OVERLOAD!" or "INPUT 1 (2)
OVERLOAD!" appears
→ The input sound is too loud. Increase the dis-
tance between the mic and the sound source.
→ Wind can also cause loud noises to be input. We
recommend using the Lo Cut setting to reduce
noise if air is blown directly at a mic, for example,
when recording outdoors or when a mic is near
the mouth of a speaker.
Recording is not possible
→ Confirm that the microSD card has open space.
→ Confirm that a microSD card is loaded properly
in the card slot.
Product names, registered trademarks and company names in this document are the property of their respective companies.
The microSDXC logo is a trademark of SD-3C LLC.
USB Type-C is a trademark of the USB Implementers Forum.
All trademarks and registered trademarks in this document are for identification purposes only and are not intended to infringe
on the copyrights of their respective owners.
Recording from copyrighted sources, including CDs, records, tapes, live performances, video works and broadcasts, without per-
mission of the copyright holder for any purpose other than personal use is prohibited by law. ZOOM CORPORATION will not
assume any responsibility related to infringements of copyrights.
The illustrations and display screens in this document could differ from the actual product.
ZOOM CORPORATION
4-4-3 Kanda-surugadai, Chiyoda-ku, Tokyo 101-0062 Japan
The recorded sound breaks up
→ Test the microSD card.
See the Operation Manual for details.
→ Use the H4essential to format the microSD card.
→ We recommend using microSD cards that have
been confirmed to operate with this product.
See the ZOOM website (zoomcorp.com) for
information about microSD cards that have been
confirmed to work with this unit.
Not recognized by computer when connected
→ Use a USB cable that supports data transfer.
Date and time are reset frequently
→ If power is not supplied by an AC adapter or
batteries for a long time, date and time settings
will be reset.
If the Set Date/Time Screen appears during start-
up, set them again.
Operation is not possible
→ Confirm that
zoomcorp.com
is not set to HOLD.
Z2I-5091-01
Advertisement
Table of Contents
