Table of Contents
Advertisement
FIGURE 3.
ATTACHING THE BRAKE CABLE
1. The brake cable is attached to the engine, and has
a "Z" fitting on the loose end. Route the brake
cable in back of the engine, to the outside of the
height adjustment handle and handle mounting
bracket, and below the lower handle. Place end
of cable into the upper hole on the bottom of the
control housing, and through the slot as shown.
The angle of the plastic flange must be positioned
-downward as shown in figure 3. Be careful not to
bend or kink the cable at any time.
2. Push the plastic fitting until it locks into the con¬
trol housing.
A
WARNING: Brake cable must be assem¬
bled as shown for proper blade brake
operation.
3. Hook the "Z" end of the brake cable into the hole
in the blade control handle from the inside to the
—outside as shown in figure 4.
FIGURE 5.
ATTACHING THE THROTTLE CABLE
1. Push the throttle control lever on the handle all the
way forward to CHOKE position. See figure 5.
2. The throttle control cable is attached to the upper
handle. Route the throttle control cable under the
lower handle. Route the cable to the outside of the
handle wheel bracket assembly and height adjust¬
ment lever then in back of the engine. Hook the
"Z" end of the throttle control cable into the hole
-in the control lever on the engine shown in figure 5.
3. Using a screwdriver, remove the screw and cable
clamp shown in figure 5.
4. Push the control lever on the engine as far toward
the rear of the engine as it will go. Secure the cable
in this position with the cable clamp and screw.
7
Advertisement
Table of Contents
