Pioneer SX-2700 Operating Instructions Manual page 9

FRONT PANEL FACILITIES
@3 FM TUNING AUTO/MANUAL switch
Works during FM reception.
DIRECT ACCESS tuning switch
if the input station falls outside of the receiver's tuning Tange, the display
section will display a message: ''UPPER'' if the frequency is too high
and "LOWER" if it is too iow (see page 11}.
G8) GRAPHIC EQUALIZER controls
The equalizer is divided into five frequency ranges (100 Hz, 330 Hz,
1 kHz, 3.3 kHz, 10 kHz} to tailor music to the individual taste of the
listener.
@@} CUSTOM MEMORY switches
(2 OPERATION DISPLAY panel
{a} Indicates the function or frequency by the function switches.
{b} TUNED indicator
{c} FM STEREO indicator
{d) FM MONO indicator
{e} TUNING AUTO/MANUAL indicator
{f} DIRECT ACCESS tuning indicator
{g) SIMULATED STEREO indicator
(h} CUSTOM MEMORY indicator
{3 Indicates channel, STATION CALL number or sleep time.
{j) SCAN indicator
{k} MEMORY indicator
{i} TAPE 2 monitor indicator.
{a}
i ieeeseonen
asp] ial i i li) KA | G===]—0
em lili Ut LANE. IN
WM MHz
ik
sean
(
(b) Tun]
Zita h[ SuBroM
ce
sration
TUNING
te) (f) {g) (h) i)
@® TUNING switches (DOWN, UP)
UP: The FM or AM band is scanned in the direction of increasing
frequency.
DOWN: The opposite operation to that of the UP switch takes place
SIMULATED STEREO switch
NOTE;
This function can also be used with stereo sources, but it will result
in a different sound from the normal stereo sound.
@ Remote sensor window
Set the MASTER VOLUME
control to the "'0'' position.
Press the SPEAKERS switch
O Ne Set the BALANCE control
corresponding to the speaker——__ tS —
system to be used. e
—— |
TEEEER LE ee Se eer
to the center position.
|
Set the TAPE 2 MONITOR switch to OFF
(TAPE 2 indicator goes off}.
<
<ARB1213~