Pioneer SX-2700 Operating Instructions Manual page 8

FRONT PANEL FACILITIES
@ PIONEEr
@ POWER (STANDBY/ON) switch
* The accessory remote control unit can also be used to operate
STANDBY/ON and SLEEP function of this switch.
« The POWER switch selects the transformer secondary even in
STANDBY position. The unit circuitry will work as long as the power
cord is connected to a wall socket.
¢ When not using the unit for a long period, disconnected the power
cord.
NOTE:
When the power is initially turned ON, muting will be applied to prevent
sound from being output for about 5 seconds.
2) SPEAKERS switches ( = OFF, = ON)
These are used to select the speaker through which you wish to listen.
A: When the speakers connected to A terminals are in use.
B: When the speakers connected to B terminals are in use.
* Turn both A and B speakers to OFF pasition when only the
HEADPHONES are in use
NOTE:
Ne sound will be heard through the speakers when both A and B
switches are depressed if only one set of speakers has been connected
to either A or B SPEAKERS terminals.
(3: PHONES jack
Connect the plug on your headphones fo this jack. To listen to a program
through the headphones, set both SPEAKERS A and B switches to the
OFF position.
(4; BAND Selector switches
These switches are used to select either AM or FM reception.
AM: Push this switch for AM reception.
FM: Push this switch for FM reception.
(8) STATION CALL switches
These switches are used to preset and recall desired broadcasting
stations.
(6) MEMORY switch
When the unit is in the frequency display mode, pressing this switch
will result in the memorization of the current broadcast band, reception
frequency, and FM AUTO;MONO mode.
This switch is also used to input custom memory names (see page 13).
8
<ARB1213>
@ TAPE 2 MONITOR switch
Press when listening to tape playback with the cassette deck 2.
SCAN switch
@) Function switches
Use to select playback source
(TAPE 1 /DAT} ~ Press when listening to tape playback with the
cassette deck 1 or digital audio tape deck.
[CD] — Press when listening to compact disc playback with a CD player.
ITUNER} — Press when listening to AM or FM broadcasts with a tuner.
[PHONO] — Press when listening to record playback on a turntable,
40 FM MODE AUTO/MONO selector switch
Use to select the auto stereo mode or monaural mode when listening
to FM broadcasts. The monaural mode has been selected when the FM
MONDO indicator is lighted.
Auto stereo mode:
Normally leave in this mode for reception. When a stereo FM broadcast
is received, it will be automatically reproduced in stereo sound.
Monaural mode:
When receiving distant stations or stations with weak broadcast signals,
the input signal may be weak. thus resulting in increased noise during
FM stereo broadcasts. In this event, setting the receiver to the monaural
made will reduce the noise. In this case, however, FM stereo broadcasts
will be reproduced in monaural sound.
NOTE:
This switch has no effect on reception of AM broadcasts.
(@) BALANCE control
Shouid normatly be feft in the center position. Adjust balance if the sound
is louder from one of the speakers, If the right side is louder, turn toward
the L position and if the jeft side is louder, turn toward the R position.
2 VOLUME control
Use to adjust volume level.