Remote switch setting
• Remote controller address setting (SW3)
This switch can be used when group control system. Set the remote controller address in the
1,2,-,15 order.
SW3
0
1—15
Jumper wire setting
• JM1 and JM2 setting prohibited
• Fan delay setting (JM3)
→hen the indoor unit is stopped while operating in conjunction with auxiliary heater, the indoor
unit fan operation will continue for one minute.
Connect
Disconnect
1-1. Function settings on indoor unit
Remote controller address
JM3
SW state
Single
JM state
Disable
Enable
- (05-2) -
Factory setting
♦
Factory setting
♦
1. Function settings for indoor unit