Advertisement
Refer to P.30 fot an-explanation of VSX-501
VSX-511S REMOTE CONTROL
OPERATION
1. Open the battery compartment cover on the rear of the remote
control unit. The cover should open easily if you slide it in the
direction of the arrow while pressing on it with your thumb.
2, Take out the two supplied batteries (IEC LR6/AM-3), and insert
them
into the battery compartment
in accordance
with the
indications in the compartment.
3. Press the reset button.
4, Close the cover of the battery compartment.
Reset button
Cover
Incorrect use of batteries may lead to leakage or rupture.
Always be sure to follow these guidelines:
A.
Always insert batteries into the battery compartment correctly matching
the positive
+ and negative
—
polarities, as indicated inside the
compartment.
|
remote control operation,
B.
Never mix new and used batteries.
c.
Batteries of the same size may have different voltages, depending on
their type. Do not mix different types of batteries.
REMOTE CONTROL RANGE
When operating the remote control unit. point the front of the unit at
the front panel of the receiver. The remote control unit may be used
within a range of about 7 meters (23 feet) from the remote sensor,
within angles of up to about 30 degrees,
Performance of the remote control unit is adversely affected in the
presence of strong fluorescent light. Keep such lights away, especially
from the sensor window.
7 m (23 feet)
Battery Replacement
When the batteries have run out, the CONTROL MODE buttons will not
fight properly. If left like this, programs will be erased, so be sure to
replace the batteries as soon as possible. Remove the old batteries only
if they can be replaced by new ones immediately.
Also, be sure to always
use
the specified
batteries
{size "AA"
(IEC LR6/AM-3) alkaline batteries).
NOTE:
When no batteries are inserted, the pregrammed memory contents will
be erased after about 30 minutes.
When you want to clear the Pragrammed memory, refer to page 43.
The memory cannot be cleared simply by removing the batteries.
OUTLINE OF BUTTON LAYOUT
* The buttons on the lower half of the remote control command receiver
functions.
¢ Buttons on the upper half are used to operate other components.
® Operation buttons for other components can learn the command
signais of other remote control units.
® There are 12 kinds of preset signals for operation of VCR 1, VCR 2,
and TV. Select and use one of them.
® A maximum of seven commands can be programmed into the MULTI
COMMAND
button,
enabling
transmission
of a sequence
of
commands at the push of a button.
CONTROL MODE
buttons (Page 37)
MODE CHECK button
(Page 40)
Receiver control
buttons (Page 36)
LEARN button
(Page 41)
EDIT button
{Page 41)
MULTI COMMAND
button (Page 43)
-—-—— Operation buttons
{Page 37)
These buttons can
be programmed with
remote control units.
commands of other
(Page 41)
35
<ARBI1378>
Advertisement
