Notes On Schematic Diagram; Top View - Sharp MD-MS701H(BL)2 Service Manual

MD-MS701H2/MS702H2
NOTES ON SCHEMATIC DIAGRAM
¢ Resistor:
To differentiate the units of resistors, such symbol as K and
M are used: the symbol K means 1000 ohm and the symbol
M means 1000 kohm and the resistor without any symbol is
ohm-type resistor. Besides, the one with "Fusible" is a fuse
type.
* Capacitor:
To indicate the unit of capacitor, a symbol P is used: this
symbol P means micro-micro-farad and the unit of the
capacitor without such a symbol is microfarad. As to electro-
lytic capacitor, the expression "capacitance/withstand volt-
age" is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
CRERNO [DESCRIPTION | POSITION ]
OFF—ON
OFF—-ON
1, 2 3
28A1314 C
25A2982 C
TOP VIEW
SBo0208CP
DA221
188373
* The indicated voliage in each section is the one measured
by Digital Multimeter between such a section and the chas-
sis with no signal given.
* Parts marked with "/A\ " (I. = = == 2) are important for
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.
DTC144 TE 28042138
TOP VIEW
SB00703Q
Figure 23 TYPES OF TRANSISTORS AND DIODES
S05.