Advertisement
Caution for safe use
of this apparatus
(For UNITED KINGDOM)
Caution
This apparatus is double insulated, safety earth not required.
Important
The wires in this mains lead are coloured in accordance with
the following code:
Blue:
Brown:
Neutral
Live
As the colours of the wires
in the mains lead of this apparatus
may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows.
The wire which is coloured BLUE must be connected to the
terminat which
is marked
with the letter N or coloured
BLACK.
The wire which is coloured BROWN
must be con-
nected to the terminal which is marked with the letter L or
coloured RED.
This equipment should be disconnected from the mains
when not in use.
Before use
Caution:
Do not plug in the AC power plug before completing assembly.
Attach the dust cover last to make assembly and adjustments
easier.
These instructions apply to units of different color.
@ Checklist of parts
Turntable unit ........
eee e eee S o p
delat Glniagd we aware aerevinge 1
Turntable platter .
.
Turntable mat ........6eee-
.
1
Dust COVEr .....
cece eee eee
45-rom adaptor
Counterweight
Headshell/cartridge.....
6... seer ereeeeee '
@ Installing the turntable platter
1, Place the platter on the center spindle.
2. Holding the belt by the ribbon, fit the belt over the
capstan. Then remove the ribbon. (Fig. 1)
3. Place the turntable mat on the platter.
Note:
After placing the mat on the platter, turn the platter
clockwise about ten full rotations by hand.
This
is necessary
to assure
correct
operation
of the
automatic mechanism.
:
pressure (tracking force)
Note:
4. After balancing the tonearm, clamp the tonearm into the
arm rest.
5. While holding the counterweight stationary, rotate the
weight ring so that the "0" on the ring scale is lined up
with the center line on the tonearm shaft. (Fig. 6)
This
completes
tonearm
balancing
(horizontal
zero
balance).
6. Turn the counterweight in the direction of the arrow so
that the weight ring shows the correct stylus pressure
number lined up with the center line. (Fig. 7)
(Follow the cartridge manufacturer's recommendation.)
When the counterweight is turned, the weight ring moves
with it. Stylus pressure is indicated by the number on the
scale aligned with the center line.
Note:
Set the stylus pressure to the maximum
recommended
value for your cartridge in cases where the record has an
extremely
high recording
level, or where the unit is
operated in a room at low temperature, or in places in
which the unit is subjected to vibrations.
@ Adjusting the anti-skating control (Fig. 8)
Set the anti-skating control to the same value as the stylus
pressure.
Note:
When a cartridge with integral dust brush is used, follow
the cartridge manufacturer's recommendation for adjust-
ing both stylus pressure and anti-skating control.
@ Attaching the dust cover (Fig. 9)
Hold
both
sides of the cover and
lower it into the hinge
slots. To remove the cover, open it and pull upward.
Note:
Opening or closing the cover during play may cause
vibrations and groove skipping.
If you must open the cover during play, do so very gently.
Advertisement
