Installing The Appliance Into A Rack - Extreme Networks NetSight NS-A-20 Installation Manual

2 Remove the left end of the front bezel from rack handle.
3 Rotate the front bezel counterclockwise to release the latches on the right end from the rack handle.
Installing the Front Bezel
Note
Before installing the bezel, you must install the rack handles. See
a Rack on page 12.
To install the front bezel:
1 Lock the right end of the front bezel to the rack handle.
2 Rotate the front bezel clockwise till the left end clicks into place.
3 Lock the bezel, if needed.

Installing the Appliance into a Rack

A rack mounting kit and installation guide are included with the NS-A-20 appliance. The rack mounting
kit allows you to install the appliance into a four-post rack cabinet. Refer to the installation guide for
complete installation instructions.
If you are table mounting the appliance, ensure at least 6 cm of clearance on all sides of the appliance
for proper ventilation.
If you are installing the appliance in a rack:
1 Install the rack handles by aligning a rack handle with the two holes on each side of the appliance
and attaching each handle to the appliance with two screws as shown in
Figure 4: Installing the Rack Handles
2 Read the installation guide included with the rack mounting kit.
3 Install the rails and mount the controller in the rack as instructed.
Torque Values
The table below describes the recommended torque values to use when installing the appliance using
standard threaded fastener machine screws and bolts.
NetSight NS-A-20 Installation Guide
Appliance Overview and Setup
Installing the Appliance into
the figure below.
12