Installing The Engine Into A Rack - Extreme Networks ExtremeAnalytics PV-A-305 Installation Manuals

3 Rotate the front bezel counterclockwise to release the latches on the right end from the rack handle.
Installing the Front Bezel
Note
Before installing the bezel, you must install the rack handles. See
Rack on page 12.
To install the front bezel:
1 Lock the right end of the front bezel to the rack handle.
2 Rotate the front bezel clockwise till the left end clicks into place.
3 Lock the bezel, if needed.

Installing the Engine into a Rack

A rack mounting kit and installation guide are included with the PV-A-305 engine. The rack mounting
kit allows you to install the engine into a four-post rack cabinet. Refer to the installation guide for
complete installation instructions.
If you are table mounting the engine, ensure at least 6 cm of clearance on all sides of the engine for
proper ventilation.
If you are installing the engine in a rack:
1 Install the rack handles by aligning a rack handle with the two holes on each side of the engine and
attaching each handle to the engine with two screws as shown in
Figure 4: Installing the Rack Handles
2 Read the installation guide included with the rack mounting kit.
3 Install the rails and mount the controller in the rack as instructed.
Torque Values
Table 9 describes the recommended torque values to use when installing the engine using standard
threaded fastener machine screws and bolts.
ExtremeAnalytics® PV-A-305 Installation Guide for version 8.1
Engine Overview and Setup
Installing the Engine into a
Figure 4.
12