Connecting Cables; Notes - Cobra CPI1590-CBL Operating Instructions Manual

Intro Operation Customer
Assistance

Connecting Cables

Installation
Installation
Connecting Cables
Power wire and wiring are very important to the
Secondary Icons
performance of the inverter . Because the inverter has a
low voltage, high current input, low resistance wiring is
essential between the battery and inverter . This is so it
Main Icons
can deliver the maximum amount of energy to the load .
Notice Caution
Use only the supplied cables .
To connect the cables between the
inverter and the battery:
Intro
1. Press the Power Button on the inverter to the off
position . If the power source is a DC power supply,
switch it off as well .
Power Button
Secondary Icons
2. Connect the cables to the Power Input Terminals on the
input end of the inverter . The red terminal is positive (+)
and the black terminal is negative (-) .
It is a good idea to check and tighten these screws from
time to time . They can become loose by vibrations or
thermal cycling .
Connect Cables
8
Warranty

Notes

Warning
Operation Customer Warranty
Assistance
Installation
Notes
Notice Caution Warning
Intro Operation
Installation
Main Icons
3. Connect the cables to the power source:
Installation
•
a. Connect the cable from the Negative (Black) Terminal
Secondary Icons
of inverter to the Negative Terminal
of the power source . Make a secure connection .
Intro Operation Customer
Assistance
Notice
Installation
Secondary Icons
NOTE Please install the supplied plastic protector
boots on the input terminals to prevent a short circuit .
Notice Caution
Customer Warranty
Assistance
Connecting Cables
Notes
Warranty
Caution Warning
Notes
Warning
Nothing Comes Close to a Cobra 9
™