Frequency Selection; Frequency Step Selection - Kenwood TH-77A Instruction Manual
144/440mhz fm dual bander
Hide thumbs
Also See for TH-77A:
- Service manual (92 pages) ,
- Instruction manual (56 pages) ,
- Instruction manual (83 pages)
Table of Contents
Advertisement
4-2-2.
Frequency Selection
Rotate
the
Tuning
control
to
select
the
MAIN
band
frequency.Press the UP /DWN
key to select the SUB band
frequency.
@
Direct keyboard frequency entry
1. Press the ENT key to select the ENTER mode.
2. Within 10 seconds
of pressing the ENT key enter the
frequency from most significant digit to the least significant
digit.
The
transceiver
changes
frequency
after
1 kHz
digits
have been entered (1 kHz digit is not displayed).
If 1kHz digit
indicator
flashes,
enter the 1 kHz digit
frequency.
Before
nce
entering 1kHz
OT
4 Id ERs)
digit 5 indicator
B AP
may flash.
If you make an error before entering all digits, press the
ENT key twice , then reenter all .
In 12.5 kHz ,or 25 kHz step size direct frequency se-
lection will be completed
in the 10 kHz digit. When
you enter the following keys for the 10 kHz digit, 1
kHz and 100 Hz digit
frequencies
are automatically
selected from the list below.
4-2-3.
Frequency Step Selection
To select the desired tuning or scan step size use the fol-
lowing procedure:
1. Press the F key momentarily, then press the MHz/STEP
key.
The
current
frequency
step
size
will
be
dis-
played.
fuga one
J
oi a
Be
| pia
Advertisement
Table of Contents
