Panasonic Bread Bakery SD-253 Operating Instructions & Recipes page 46

A5
Condition
Reason/Cause
TEMP
appears
on
display.
TEMP
The unit is hot (above 40°C/105°F).
This may occur during repetitive use.
You must allow the unit to cool down
before reusing.
How to reset/restart
Leave the unit as it is.
OF
Not baked at all, although
the operation appears to
have proceeded.
POWER ALERT
POWER ALERT | is on
display.
men
Lees
is on
PEPE ;
Le-meng | display.
There has been a 10-minute or
less power cut. (The power plug
has been inadvertently pulled out or
the breaker has activated.)
Or there has been a slight change in
the power supplied to the machine.
Motor protection device has activated.
This only happens when the unit is
overloaded and an excessive force
is applied to the motor.
After about 30 minutes, the motor
automatically starts running again.
Motor protection device
Service will
be required.
Make sure you did not use
too much or too hard/heavy
ingredients, then start again
using all new ingredients.
Remedy 1
Remedy 2
unit will restart 30 minutes later.
service will be required.