Torque Instructions
Instructions
Torque
Torque
Instructions
If diaphragm cover or vapor cap fasteners have been
loosened, it is important to torque them using the
following procedure to improve sealing.
NOTE: Cover and cap screws have a thread-locking
NOTE:
NOTE:
adhesive patch applied to the threads. If this patch
is excessively worn, the screws may loosen during
operation. Replace screws with new ones or apply
medium-strength (blue) thread locker to the threads.
NOTE:
NOTE: Always completely torque covers and caps
NOTE:
before tightening manifolds.
1. Start all screws a few turns. Then, turn down
each screw just until head contacts cover.
2. Turn each screw by 1/2 turn or less working in a
crisscross pattern in the order shown to specified
torque.
Diaphragm covers
covers and
Diaphragm
Diaphragm
covers
in-lb (10.2 N•m)
3A7034A
and vapor
vapor cap
cap screws:
screws: 90
and
vapor
cap
screws:
Torque Instructions
15