Disposing Of Waste - Toro 77505 Operator's Manual

Washing the Underside of the Mower Deck (continued)
3. Attach a hose
attach the hose coupling to the end of the
mower washout fitting
high.
Note:
fitting O-ring
easier and protect the O-ring.
4. Sit on the seat, lower the mower to the lowest
height-of-cut, and start the engine.
5. Engage the blade-control switch and let the
mower run for 1 to 3 minutes.
6. Disengage the blade-control switch, shut off
the engine, remove the key, and wait for all
moving parts to stop.
7. Turn the water off and remove the coupling from the washout fitting.
Note:
Then repeat the process.
8. Run the mower again for 1 to 3 minutes to remove excess water.
A broken or missing washout fitting could expose you and others to thrown objects
or blade contact. Contact with a blade or thrown debris can cause injury or death.
• Replace broken or missing washout fitting immediately, before using machine
again.
• Never put your hands or feet under the mower or through openings in the
machine.

Disposing of Waste

Engine oil, batteries, hydraulic fluid, and engine coolant are pollutants to the environment.
Dispose of these according to your state and local regulations.
3465-589C
to the hose coupling
and turn the water on
Spread petroleum jelly on the washout
to make the coupling slide on
If the mower is not clean after 1 washing, soak it and let it stand for 30 minutes.
, then
g020098s
WARNING
Page 5–33 Maintenance: Cleaning