Table of Contents
Advertisement
16
www.aeg.com
7.3 Introduction
The options/functions are
not selectable with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
7.4 Finish In
Set this option as last after
programme and other
options selection, otherwise
it can be cancelled if you
change some setting.
This option allows choosing the time
within which a programme should
terminate. The programme end can be
postponed by one 1 hour every button
touch until 24 hours maximum.
The display shows the normal
programme duration alternatively with
the set programme end time (expressed
in hours 0h). The minimum selectable
time corresponds to rounded up hour of
the maximum duration of a programme
(e.g. if the cycle duration lasts 3:15
hours, the minimum selectable time will
be 4h).
After programme start, the door is locked
and the appliance starts the ProSense
phase. When load estimation ends, on
the display the icon of running phase
blinks and the time digit counts down in
steps of one hour and in steps of 1
minute during the last hour.
7.5 Start / Pause
Touch the Start / Pause
start, pause the appliance or interrupt a
running programme.
7.6 PODS®
Touch this button to activate or
deactivate the PODS® option .
When activated the relevant indicator is
on.
Follow the Pods manufacturer's dosage
and storage recommendations.
Put maximum two tablets or single-dose
detergents in the PODS® compartment
in the detergent dispenser drawer.
The option remains active also for next
cycles until it is deactivated and if it is
selectable with the set programme.
7.7 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The Plus Steam option achieves good
results with a small load because steam
better penetrates the laundry if there is
more space. For this reason, the
programme maximum load combined
with this option is 2 kg (approximately 8 -
10 shirts).
When setting the Plus Steam option, the
maximum load drops to 2 kg in the
display and programme time is adjusted
accordingly.
The indicator
during steam phase.
When the programme stops the display
shows a zero
steady on.
The anti-crease phase starts, the
indicator
Pause
performs smooth movements for about
30 minutes to keep the steam benefit.
button to
To interrupt the anti-crease phase, you
can:
blinks in the display
This option can affect the
programme duration.
, the indicator
is blinking, and the Start /
led remains lit. The drum
is
Advertisement
Table of Contents
