Sony LBT-G1000 Operating Instructions Manual page 9

You can store station frequencies in the unit's memory for quick recall later on. Up to 30
frequencies in any band can be stored by specifying a code for each frequency. The code
is a combination of a letter - A, B or C — and a number — 0 to 9: A-1, A-2, ..., A-9, A-0, B-1,
sop C-L, see C-O.
5 Press the DUAL MODE TUNING + or - button
to select a number (0 - 9).
Press the MEMORY button. "PRESET" and
"MEMORY" disappear.
A code is specified and the setting of the STEREO/
MONDO button is also stored. One second later, the
code disappears and the tuner enters the tuning
mode again.
if you cannot store a station successfully
1 Press the TUNING/PRESET button to enter the Be sure to press the buttons for the code while the
tuning mode. "MEMORY" indicator lights. If the indicator has gone off,
"PRESET" and the preset code disappear. press the MEMORY button again.
To erase a stored station
Storing a new station on a used code erases the previously
stored one.
To select the preset channel directly using the DUAL
Press the BAND button and the DUAL MODE MODE TUNING buttons
TUNING + or - button to tune in the desired Each time you press the DUAL MODE TUNING button in
station. (See page 8.) step 4, the code (combination of a letter and a number) can
be selected without pressing the SHIFT button and you can
skip to step 6. The preset channel changes as follows:
Press the MEMORY button. "PRESET" and
id "MEMORY" appear on the display.
While a number of the last memorized code is C Al - A2«----> A9 +> AQ<— B1 <----> BO +» Cl1<-»> CO a
blinking, proceed to step 4.
3 CA
_ _
Press the SHIFT button to select a fetter (A, B Tuning into a Stored Station
or C).
The last memorized number with the selected letter 1 Press the TUNING/PRESET button to enter the
preset mode. ("PRESET" and the preset code
PRESET MES Tunes
—
appear.)
— 2 Press the SHIFT button and the DUAL MODE
TUNING + or - button to specify the code for the
desired station.
i 9