Sony CDP-C365 Operating Instructions Manual page 15

yVololhalelsy-}miataelatiych 41*)2)
Troubleshoofing
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
=> Check that the player is connected securely.
=> Make sure you operate the amplifier correctly.
The CD does not play.
=>There's no CD inside the player ("no dISC"
appears). Insert a CD.
=>Place the CD with the label side up on the disc
tray correctly.
=>Clean the CD (see page 14).
=> Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 14).
The remote does not function. (CDP-C365 only)
=> Remove the obstacles in the path of the remote
and the player.
=>Point the remote at the remote sensor HM on the
player.
=> Replace all the batteries in the remote with new
ones if they are weak.
The player functions incorrectly.
=>The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Specifications
Compact disc player
Laser Semiconductor laser
Wavelength 780 — 790 nm
Frequency response 2 Hz to 20 kHz + 0.5 dB
Signal-to-noise ratio More than 102 dB
Dynamic range More than 98 dB
Harmonic distortion Less than 0.0045%
Channel separation More than 100 dB
Output
Jack Maximum Load
type output impedance
level
LINE OUT Phono 2V Over 10 kilohms
jacks (at 50 kilohms)
General
Power requirements
Where purchased Power requirements
USA 120 V AC, 60 Hz
Australia 240 V AC, 50/60 Hz
Power consumption 144W
Dimensions (approx.) 430 x 125 x 385 mm
(wih/d) (17x 5.x 15 1/4 in.) incl. projecting
parts
Mass (approx.) 5.6 kg (12 Ibs 6 oz)
Supplied accessories
Audio cord (2 phono plugs - 2 phono plugs) (1)
Remote commander (remote) (CDP-C365 only) (1)
Sony SUM-3 (NS) batteries (CDP-C365 only) (2)
Design and specifications are subject to change without notice.
15