LG F14A8YD Series Service Manual page 8

3
se spanner to remove transit bolts.
4 Confirm the distance between the appliance and the wall.
More than 2cm
5 The tap connection and hose connection must be parallel.
■
Connecting water supply hose
• Water supply pressure must be between 100 kPa and 1000 kPa (1.0 ~ 10.0 kgf / cm
• Do not strip or crossthread when connecting Inlet hose to the valve.
• If the water supply pressure is more than 1000 kPa, a decompression device should be installed.
• Periodically check the condition of the hose and replace the hose if necessary.
Step1 : Check rubber seal inlet hose
Hose
connector
Rubber
seal
Step2 : Connect hose to water tap
Type-A : Connecting Screw-type hose to tap with thread
Type-B : Connecting Screw-type hose to tap without thread
Upper
connector
Fixing screw
Water supply
hose
Transit bolts
• Two rubber seals are supplied with the water inlet hoses.
They are used for preventing water leaks. Make sure the connection to
taps are sufficiently tight.
• Screw the hose connector onto water supply tap.
1. Unscrew the adapter ring plate and the 4 adapter retaining screws.
Rubber
2. Push the adapter onto the end of the tap so that the rubber seal forms
packing
a watertight connection. Tighten the adapter ring plate and the 4
screws.
3. Push the water supply hose vertically upwards so that the rubber
packing within in the hose can adhere completely to the tap and then
tighten it by screwing it to the right.
Plate
Without removal of transit bolts
pin noise
X 4 EA
If the distance is less than 2cm,
the water supply hose will
or .
kink fold
2 )
9
and .
shaking