Installation; Selecting A Location; Setting The Dial Mode Switch; Desk Or Tabletop Installation - Uniden EXP91 Owner's Manual

Selecting a Location

Before choosing a location for your new phone, read the
"Installation Considerations" included in the "Precautions and
Important Safety Instructions" brochure.
Important: Place the power cord so that it does
not create a trip hazard, or where it could
become chafed and create a fire or other
electrical hazards.

Setting the Dial Mode Switch

Place the switch in the
T position for tone dialing,
or the P position for
pulse dialing.

Desk or Tabletop Installation

1. Plug the AC adapter
cord into the 9V DC
input jack on the base.
2. Wrap the AC adapter
cord inside the
molded strain-relief.
3. Plug one end of the long
telephone cord into the
TEL LINE jack on the base.
4. Raise the antenna on the base.
5. Plug the other end of the
telephone cord into the
telephone wall jack.
6. Plug the AC Adapter into a standard 120V AC wall outlet
that is not controlled by a wall switch.
Use only the AC adapter that came
with the phone.

Installation

Wall Installation

Setting the Handset Retainer For Wall Mounting

1. Remove the handset
retainer on the base by
sliding it upward.
2. Flip the retainer over so
the tab is facing up.
3. Slide the retainer back
into the base.

Mounting on a Standard Wall Plate

The phone is designed to be mounted on a standard AT&T or
GTE wall plate.
1. Plug the AC Adapter
into the base.
2. Place the AC Adapter
cord inside the left
channel cord holder.
3. Plug a short
telephone cord
into the phone
and the wall
plate jack.
4. Place the base on
the two posts of
the wall plate and
slide downward
to secure.
5