Gigabyte Z390 AORUS ULTRA User Manual page 18

8) EC_TEMP1/EC_TEMP2 (Temperature Sensor Headers)
Connect the thermistor cables to the headers for temperature detection.
1
EC_TEMP1
1
EC_TEMP2
9) D_LED1/D_LED2 (Digital LED Strip Headers)
The headers can be used to connect a standard 5050 digital LED strip, with maximum power rating of 5A
(12V or 5V) and maximum number of 1000 LEDs. There are 12V and 5V digital LED strips. Be sure to
verify the voltage requirements of your digital LED strip and set the DLED_V_SW1 and DLED_V_SW2
jumpers accordingly.
1
D_LED1 D_LED2
Digital LED Strip
Adapter Cable
1
10) DLED_V_SW1/DLED_V_SW2 (Digital LED Strip Power Select Jumpers)
The jumpers allow you to select the supply voltage of the D_LED1 and D_LED2 headers. Be sure to
verify the voltage requirements of your digital LED strip and set the correct voltage with this jumper before
connection. Incorrect connection may lead to the damage of the LED strip.
1-2: 5V (Default)
1
2-3: 12V
1
DLED_V_SW1
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
Pin No. Definition
1 SENSOR IN
2 GND
Pin No. Definition
1 V
1
2 D
3 No Pin
4 G
Connect one end of the included digital LED strip adapter cable to
this header and the other end to your digital LED strip. The power pin
(marked with a triangle on the plug) of the LED strip must be connected
to Pin 1 of the digital LED strip header. Incorrect connection may lead
to the damage of the LED strip.
1-2: 5V (Default)
1
2-3: 12V
1
DLED_V_SW2
- 18 -