Table of Contents
Advertisement
SECTION 3: FINDING MODEL NUMBER
This owner's guide is an important part of your new lawn mower.
It will help you assemble, prepare and
maintain your mower.
Please read and understand what it says.
Before you start assembling
the mower for its first use, please locate its model plate and copy the
information
on to this owner's guide.
The information
on the model plate is very important if you need
help from your dealer or the MTD customer support department.
• Every mower has a model plate. You can locate it by standing behind the unit in the operating
position and looking down at the cutting deck.
• The model plate will look like Figure 1.
__±
XXX-X-XXX-X-XXX
XXXXXXXXXXX
_,lwlrD_
MTD PRODUCTS
INC
_I_E_
CLEVELAND, OHIO 44136111
This is where mower model number will be.
This is where mower serial number will be.
Copy the model number here:
Copy the serial number here:
Figure 1
SECTION 4: UNPACKING
Removing
Unit From Carton
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e., owner's manual, etc.).
• Cut along dotted lines and lay carton down flat.
• Remove packing material.
• Roll or slide unit out of carton. Check carton thoroughly for loose parts,
SECTION 5: SETTING UP
IMPORTANT:
This unit is shipped WITHOUT GASOLINE or OIL. Be certain to service engine with
gasoline and oil as instructed in the separate engine manual before operating your mower.
NOTE: Reference to right or left hand side of the mower is observed from the operating position.
Tools Required
Pair of pliers (not necessary, but helpful)
Assembling
Mower
• Remove any packing material which may be between the upper and lower handles for shipping
purposes.
Advertisement
Table of Contents
