Bmw Integral Abs - Troubleshooting Chart - BMW R 1150 RS Rider's Manual

BMW Integral ABS
General war- ABS warning
ning light e light l/
brake failure
OFF ON
OFF Flashes at 1 Hz ABS not available
OFF Flashes at 4 Hz Only RESIDUAL BRAKING FUNCTION
ON OFF
ON Flashes at 1 Hz At least one brake circuit without
ON Flashes at 4 Hz At least one brake circuit in RESIDUAL
Alternate Alternate flash-
flashing at ing at 1 Hz
1 Hz
Alternate flas- Alternate flas-
hing at 4 Hz hing at 4 Hz
OE
Optional equipment
OE
- Troubleshooting chart
Malfunctions
Only RESIDUAL BRAKING FUNCTION
available in both circuits (
Pull-away test not completed (
available in both circuits (
Self-diagnosis not completed (
Tail light/brake light inoperative
( Maintenance Instructions, Section 2)
b
ABS ( 74)
b
BRAKING FUNCTION mode (
Fluid level in BMW Integral ABS too low.
Check the motorcycle as follows:
– Ignition OFF: is brake pressure OK at
the brake levers?
– Are the brakes acting on both wheels?
– Is the brake system free from leaks, no
signs of brake fluid escaping?
If the test outcome is negative it will be
necessary to diagnose the brake system
and address any faults as necessary.
Fluid level in the BMW Integral ABS is too
low, perform the checks listed above.
Only RESIDUAL BRAKING FUNCTION
available in at least one circuit (
Do not ride the motorcycle if you
have any doubts about the depend-
ability of the brake system.
75)
b
76)
b
75)
b
76)
b
75)
b
75)
b
3 3
79