Table of Contents
Advertisement
Supplying Power
Battery Refresh Feature
This feature completely discharges the Battery before recharging begins.
To maintain your Battery's operating capacity, use the refresh feature after about every five charges.
CHARGE Lamp
1 Plug in the AC Adaptor.
* The POWER Lamp remains lit as long as the
AC Adaptor is plugged in.
2 Place the Battery into
the AC Adaptor.
button.
The CHARGE Lamp flashes until
discharge is complete and then stays lit
until the Battery is fully charged.
A
ee
the Battery.
* Should you accidentally press the BATTERY
REFRESH button, remove the Battery and
then re-insert it to begin charging.
+ it takes about 7 and a half hours when both
Battery Refresh and recharging are
rf
Battery Care
performed
Caution:
To avoid damage to the Battery:
* Charge only with specified charger.
* Do not drop or jar Battery.
e Battery can be charged within a temperature
+ Use Battery with specified units only.
range of 50° F (10° C) and 95° F {35° C).
¢ If Battery is used in extremely high
» Battery may be warm after charging or just
temperatures, a safety device will
after use. This is normal.
automatically prevent operation.
+ Do not use an insufficiently charged or worn-
out Battery.
To prolong battery life:
Safety precautions:
+ While not in use, remove Battery from the
Camcorder and AC Adaptor and store ina
cool, dark, dry place.
* Keep Battery terminals clean.
» Do not get the Battery near, or dispose of in
fire.
+ Do not directly connect (short circuit) the
positive (+) and negative (-) terminals.
+ Never attempt to disassemble or reassemble
the Battery.
U.S.A. CONSUMERS:
ATTENTION:
The product you have purchased is powered by a nickel cadmium battery which is
recyclable. At the end of its useful life, under various state and local laws, it is illegal to
dispose of this battery into your municipal waste stream. Please call 1-800-8-BATTERY
Mcd
for information on how to recycle this battery.
10
Advertisement
Table of Contents
